Refer to table a.29 list of event types – Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 User Manual
Page 213
Publication 1404-UM001D-EN-E - October 2004
Powermonitor 3000 Data Tables A-39
Table A.29 List of Event Types
Applies to:
PM3000 Type
See table
Event
Code.
M4
M5
M
6
M
8
Event type
Event Command
Code
Comment
0
•
• • No event
0
The log starts with no events recorded
1
•
• • Setpoint triggered
Setpoint Number
A setpoint activated
2
•
• • Setpoint released
A previously active setpoint released
3
•
• • Relay force energized
Relay Number
1 = Form C relay, 2 = KYZ
4
•
• • Relay force de-energized
5
•
• • Relay force released
6
•
• • Status input set
Status Input Number
7
•
• • Status input cleared
8
•
• • KWh counter set or cleared
1
Records command action
8
•
• • KVARh counter set or cleared
2
8
•
• • KVAh counter set or cleared
3
8
•
• • Ah counter set or cleared
4
8
•
• • All energy counters cleared
5
8
•
• • Trend log cleared
6
8
•
• • Min/max log cleared
7
8
•
• • Factory defaults restored
8
8
•
• • Status input #1 counter cleared
9
8
•
• • Status input #2 counter cleared
10
8
•
• • Reserved
11
8
•
• • Single setpoint timer cleared
12
8
•
• • All setpoint timers cleared
13
9
•
• • Power-up
0
Control power was applied.
10
•
• • Power-down
0
Control power was lost or internal reset occurred.
11
•
• • Selftest failure
Status Error Code
Refer to Table A.28 Status Error Codes (bitfield)
12
•
• • Date/time set
0
The date and/or time was set or altered.
13
•
• • Change of non-setpoint config data 0
14
•
• • Change of setpoint config data
0
15
•
• • NVRAM Clr
0
NVRAM has been cleared due to an extended loss
of control power or internal error.
16
• Transient detected
17
• User Comment
User has manually entered a comment to record the
impact of an event on your plant or process.
18
•
• • External Demand Sync Timeout
The demand delay expired before the next expected
external demand sync
19
•
• • Comm Card Reset
An unexpected comm card condition has been
detected and the master module has reset the
comm card in an attempt to resume normal
operation.