Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 109)

Publication 1404-UM001D-EN-E - October 2004
Communications 4-49
Select PLC5 for your Target Device, Local Network and Control Block.
Fill out the “Setup Screen” as follows:
Notice that under target device that Powermonitor 3000 data table N11
(Date and Time) was selected. The Local Node Address is the address
of the Powermonitor 3000 Controlnet Node Address “4”.
Writing data to the Powermonitor 3000 is done with the same method.
It is recommended that 1 integer file and 1 float file be set aside in the
SLC for use when writing to the Powermonitor 3000. Data to be
written to the Powermonitor 3000 is loaded in one of these files
according to data type before the transaction is started. The following
example writes data to the Powermonitor 3000:
Select PLC5 for your Target Device, Local Network and Control Block.
Fill out the “Setup Screen” as follows: