Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 User Manual, PRIOR to Firmware rev. 3.0 - Manual (Page 328)

Publication 1404-UM001D-EN-E - October 2004
G-4 Powermonitor 3000 ControlNet Device Profile
Behavior
The Powermonitor 3000 system's Identity instances handle reset
services in the following manner according to the reset type
requested:
Get Attribute Single Service
The Get Attribute Single service returns the single attribute specified
by the parameter Attribute ID.
Request Parameters
Identity Object Instances
The DC’s Identity Object supports the following instances:
Instance 1 (PM 3000)
Instance 1 represents the PM 3000 device. Since instance 1 of the
Identity Object is the one which is browsed by RS Linx, the complete
device (i.e. the PM 3000 with DC) will appear in RS Who as a PM 3000
rather than a DC.
Instance 1 of the Identity Object reports the following instance
specific attribute values:
Table G.7 Reset Behavior
Instance Reset Type Action
1 (PM 3000) 0 (Out of Box) Notify the PM 3000 and respond to the request
1 (PM 3000) 1 ( Power Cycle) Return 0x09 (Bad Attribute Data)
2 (DC) 0 (Out of Box) Notify the PM 3000 and respond to the request
2 (DC) 1 ( Power Cycle) Return 0x09 (Bad Attribute Data)
Table G.8 Get Attribute Single Service
Parameter Data Type Description
Attribute ID UINT Identifies the attribute to be read / returned