Rockwell Automation 294E ArmorStart LT EtherNet/IP Version - User Manual - Manual (Page 135)

Rockwell Automation Publication 290E-UM001B-EN-P - June 2012 135
Bulletin 290E/291E/294E Programmable Parameters Chapter 4
Speed Control Group
SpeedReference
Sets the source of the speed reference:
0 = Logix (Network or DeviceLogix)
1 = InternalFreq
Parameter Number 33
Related Parameters 1, 2, 36, 37, 72
Access Rule GET/SET
Data Type UINT
Group Speed Control
Units —
Minimum Value 0
Maximum Value 2
Default Value 0
MinimumFreq
Sets the lowest frequency the drive will
output continuously.
Parameter Number 34
Related Parameter 1, 2, 35
Access Rule GET/SET
Data Type UINT
Group Speed Control
Units x.x Hz
Minimum Value 0.0
Maximum Value 400.0
Default Value 0.0
MaximumFreq
Sets the highest frequency the drive will
output.
Parameter Number 35
Related Parameter 1, 2, 34, 35, 139
Access Rule GET/SET
Data Type UINT
Group Speed Control
Units Hz
Minimum Value 0.0
Maximum Value 400
Default Value 60
Stop drive before changing this
parameter.
O