Rockwell Automation 294E ArmorStart LT EtherNet/IP Version - User Manual - Manual (Page 103)

Rockwell Automation Publication 290E-UM001B-EN-P - June 2012 103
Bulletin 290E/291E/294E Programmable Parameters Chapter 4
PhaseL3Current
This parameter determines the actual
Phase L3 current.
Parameter Number 3
Access Rule GET
Data Type INT
Group Basic Status
Units x.xx Amps
Minimum Value 0
Maximum Value 32767
Default Value 0
AverageCurrent
This parameter determines the average of
3 Phase currents.
Parameter Number 4
Access Rule GET
Data Type INT
Group Basic Status
Units x.xx Amps
Minimum Value 0
Maximum Value 32767
Default Value 0
%ThermalUtilized
This parameter determines the percent of
Thermal Capacity used.
Parameter Number 5
Access Rule GET
Data Type USINT
Group Basic Status
Units Percent
Minimum Value 0
Maximum Value 100
Default Value 0
StarterStatus
This parameter provides the status of the
starter.
Parameter Number 6
Access Rule GET
Data Type WORD
Group Basic Status
Units —
Minimum Value 0
Maximum Value 0x4FBF
Default Value 0