Rockwell Automation 294E ArmorStart LT EtherNet/IP Version - User Manual - Manual (Page 124)

124 Rockwell Automation Publication 290E-UM001B-EN-P - June 2012
Chapter 4 Bulletin 290E/291E/294E Programmable Parameters
Bulletin 294E Basic Status Group
OutputFreq
This parameter provides the output
frequency at motor terminals T1, T2, T3.
Parameter Number 1
Access Rule GET
Data Type UINT
Group Basic Status
Units x.x Hz
Minimum Value 0
Maximum Value 999.9
Default Value 0
CommandFreq
This parameter provides the
commanded frequency even
if the starter is not running.
Parameter Number 2
Access Rule GET
Data Type UINT
Group Basic Status
Units x.x Hz
Minimum Value 0
Maximum Value 999.9
Default Value 0
OutputCurrent
This parameter provides the output
current at motor terminals T1, T2, T3.
Parameter Number 3
Access Rule GET
Data Type UINT
Group Basic Status
Units x.xx Amps
Minimum Value 0
Maximum Value 8.00
Default Value 0
OutputVoltage
This parameter provides the output
voltage at motor terminals T1, T2, T3.
Parameter Number 4
Access Rule GET
Data Type UINT
Group Basic Status
Units x.xV AC
Minimum Value 0
Maximum Value 999.9
Default Value 0