Rockwell Automation 294E ArmorStart LT EtherNet/IP Version - User Manual - Manual (Page 129)

Rockwell Automation Publication 290E-UM001B-EN-P - June 2012 129
Bulletin 290E/291E/294E Programmable Parameters Chapter 4
Trip Status Group
InternalFanRPM
This parameter determines the
Revolutions Per Minute (RPM) of the
internal cooling fan.
Parameter Number 13
Access Rule GET
Data Type UINT
Group Basic Status
Units RPM
Minimum Value 0
Maximum Value 65535
Default Value 0
ElapsedRunTime
This parameter determines the
accumulated run time displayed in 10 hour
increments.
1 = 10 Hrs
Parameter Number 14
Access Rule GET
Data Type UINT
Group Basic Status
Units —
Minimum Value 0
Maximum Value 9999
Default Value 0
DriveTemperature
This parameter determines the
present operating temperature
of the power section.
Parameter Number 15
Access Rule GET
Data Type UINT
Group Basic Status
Units °C
Minimum Value 0
Maximum Value 9999
Default Value 0
TripStatus
This parameter provides the fault
condition that caused any current trip.
Parameter Number 16
Access Rule GET
Data Type WORD
Group Trip Status
Units —
Minimum Value 0
Maximum Value 0xFFFF
Default Value 0