Lenze E94AYAE SM301 - Manual (Page 88)

5 Parameter reference
5.1 Parameter list | C15311
88
Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C15311
C15312
C15315
C15316
Parameter | Name:
C15311 | SOS: Tolerance margin (delta p=0)
Data type: UNSIGNED_32
Index: 9264
d
= 2430
h
From V1.3
Safely monitored tolerance margin for zero position change.
 Safe stop
Setting range (min. value | unit | max. value) Lenze setting
0 Incr. 327680 0 incr.
 Read access  Write access  CINH  PLC-STOP  No transfer Scaling factor: 1
Parameter | Name:
C15312 | SOS: Maximum position change
Data type: UNSIGNED_32
Index: 9263
d
= 242F
h
From V1.3
Value of the maximum position change while SOS has been active.
 Safe stop
Display range (min. value | unit | max. value)
0 Incr. 2147483647
 Read access  Write access  CINH  PLC-STOP  No transfer Scaling factor: 1
Parameter | Name:
C15315 | SS1, SS2: Ramp monitoring
Data type: UNSIGNED_8
Index: 9260
d
= 242C
h
From V1.4
Selection for whether the deceleration ramp is to be monitored when SS1 and SS2 are executed.
 Safe stop
Selection list (Lenze setting printed in bold) Info
0 No ramp monitoring
1 Ramp monitoring activated
 Read access  Write access  CINH  PLC-STOP  No transfer Scaling factor: 1
Parameter | Name:
C15316 | SS1, SS2: Ramp - S-ramp time
Data type: UNSIGNED_8
Index: 9259
d
= 242B
h
From V1.4
S-ramp time of the deceleration ramp for SS1 and SS2 if no linear ramp is used.
 Safe stop
Setting range (min. value | unit | max. value) Lenze setting
0 % 100 0 %
 Read access  Write access  CINH  PLC-STOP  No transfer Scaling factor: 1