Lenze E94AYAE SM301 - Manual (Page 5)

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
5
1 About this documentation
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
1 About this documentation
This documentation contains information on how to parameterise & configure the SM301 safety
module.
Target group
This documentation addresses to persons who want to parameterise, configure, and diagnose an
SM301 safety module attached to the Servo Drives 9400 using the L-force »Engineer« engineering
software.
Information regarding the validity
The information in this documentation applies to:
This safety module can be used together with the following standard devices:
• The use of the safety module in version 1.3 with parameter set version 1.3 and support of the 2-
encoder concept requires standard devices of the 9400 product series from nameplate
inscription:
• The use of the safety module in version 1.4 with parameter set version 1.4 and support of the
resolver as motor encoder requires standard devices of the 9400 product series from nameplate
inscription:

Tip!
Information and tools regarding the Lenze products can be found in the Internet:
http://www.Lenze.com  Download

Note!
This documentation supplements the manual for the safety module and the
documentation for the controller.
The manual for the safety module contains safety instructions which must be observed!
Safety module Type designation From hardware version From software version
SM301 E94AYAE VA 1.00
Product series Type designation From hardware version From software version
Servo Drives 9400 E94AxxExxxx VA 1.49
Product series Type designation From hardware version From software version
Servo Drives 9400 E94AxHExxxx VA 07.xx
Servo Drives 9400 E94AxPExxxx 2A 02.xx
Product series Type designation From hardware version From software version
Servo Drives 9400 E94AxHExxxx VA 08.xx
Servo Drives 9400 E94AxPExxxx 2A 02.xx