2 "ls_safetymoduleinterface" system block, Ls_safetymoduleinterface" system block, 2introduction – Lenze E94AYAE SM301 User Manual
Page 17

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
17
2
Introduction
2.5
Parameter setting & configuration
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2.5.2
"LS_SafetyModuleInterface" system block
The LS_SafetyModuleInterface system block is the interface to the safety module in the function
block editor of the »Engineer«.
Outputs
Output
Data type
Value/meaning
SMI_dnState
DINT
Bit coded status information from the safety module
SMI_dnIoState
DINT
Bit coded I/O status information from the safety module
SMI_dwControl
DWORD
Bit coded control information from the safety module
SMI_bPowerStageEnable
BOOL
Status signal "Inverter enable"
TRUE Inverter is enabled by the safety module.
SMI_byModuleId
BYTE
ID of the safety module available in the controller
60,BGZ&RQWURO
60,BGQ6WDWH
60,BGQ,R6WDWH
60,BE3RZHU6WDJH(QDEOH
60,BE\0RGXOH,G
/6B6DIHW\0RGXOH,QWHUIDFH
6DIHW\PRGXOH