Lenze E94AYAE SM301 - Manual (Page 71)

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
71
5 Parameter reference
5.1 Parameter list
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5 Parameter reference

Tip!
General information on parameters can be found in the online documentation for the
controller.
5.1 Parameter list
This chapter lists all parameters of the SM301 safety module in numerically ascending order.
C00214

Note!
This chapter supplements the parameter list and the table of attributes provided in the
online documentation for the controller by parameters of the SM301 safety module.

Note!
Parameter settings are only possible via the Safe configuration tab for the safety
module!
 Safe configuration ( 25)
Only read access is possible to the parameters of the safety module via the »Engineer«
parameter list (All parameters tab  Safety module SM301 category) and the keypad!
Parameter | Name:
C00214 | Required safety module
Data type: UNSIGNED_8
Index: 24361
d
= 5F29
h
Setting of the expected safety module.
• If a safety module is detected which does not match this setting, an error (fault) is triggered. The error can only
be eliminated by switching the mains.
Selection list (Lenze setting printed in bold)
1 SM0
2 SM100
4 SM300
5 SM301
 Read access  Write access  CINH  PLC STOP  No transfer  COM  MOT