Lenze E94AYAE SM301 - Manual (Page 113)

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
113
6 Error messages
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
F_Dest_Add unequal F address [0x012f0040]
F_Dest_Add = 0 or FFFFhex [0x012f0041]
F_Source_Add = 0 or FFFFhex [0x012f0042]
F_WD_Time is 0 msec [0x012f0043]
F_SIL exceeds technical SIL [0x012f0044]
Module ID (decimal) Error ID (decimal)
303: SM301 safety module 64
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The safety address F_Dest_Add of the control system
does not correspond to the F address in the safety
module.
Adapt the safety address in the control configuration to
the address in the safety module.
Module ID (decimal) Error ID (decimal)
303: SM301 safety module 65
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The safety address F_Dest_Add in the control system is
invalid (0 or FFFF
hex
).
Select a valid value for the safety address data in the
control configuration.
Module ID (decimal) Error ID (decimal)
303: SM301 safety module 66
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The safety address F_Source_Add in the control system is
invalid (0 or FFFF
hex
).
Select a valid value for the safety address data in the
control configuration.
Module ID (decimal) Error ID (decimal)
303: SM301 safety module 67
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The monitoring time F_WD_Time of the control system is
set to 0 ms.
Select a permissible value for the monitoring time
F_WD_Time.
Module ID (decimal) Error ID (decimal)
303: SM301 safety module 68
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The parameterised SIL setting in the control system
exceeds the technically possible SIL of the safety module.
Adapt the parameterised SIL setting in the control
system to the safety module used.