Lenze E94AYAE SM301 - Manual (Page 119)

Lenze · SM301 safety module · Parameter setting & configuration · DMS 2.3 EN · 11/2013 · TD05
119
6 Error messages
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
SS1/SS2: Speed ramp exceeded [0x012f006e]
SLI: Safely limited increment exceeded [0x012f006f]
Stuck at High SD-Out1, channel A [0x012f0080]
Stuck at Low SD-Out1, channel A [0x012f0081]
Module ID (decimal) Error ID (decimal)
303: SM301 safety module 110
Response (Lenze setting printed in bold)
 None  System error  Error  Fault  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The monitoring of the speed ramp is activated. When the
SS1/SS2 stop function is executed, the deceleration of
the speed ramp is monitored. If the monitoring limits are
exceeded, an error is reported.
• Adapt ramp monitoring parameters in the safety
module.
• Adapt (quickstop) ramp parameters in the
application.
• Deactivate ramp monitoring in the safety module.
Module ID (decimal) Error ID (decimal)
303: SM301 safety module 111
Response (Lenze setting printed in bold)
 None  System error  Error  Fault  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The safely limited increment is monitored in the "special
operation" operating mode. The increment
parameterised was exceeded.
• Adapt "SLI: Safely limited increment" parameter.
• Limit increments in the application.
• Deactivate monitoring of the safely limited
increment.
Module ID (decimal) Error ID (decimal)
303: SM301 safety module 128
Response (Lenze setting printed in bold)
 None  System error  Error  Fault  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Channel A of output SD-Out1 cannot be deactivated. Check wiring at the output SD-Out1 for short circuit.
Module ID (decimal) Error ID (decimal)
303: SM301 safety module 129
Response (Lenze setting printed in bold)
 None  System error  Error  Fault  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Channel A of output SD-Out1 cannot be activated. Check supply voltage and wiring for the safe output.