SkyTrak 3606 Service Manual - Manual (Page 383)

Electrical System
10-65 Model 3606 • Origin 10/99
10.8.12 Attachment Tilt Mode Switch
The attachment tilt mode switch (Fig. 10– 72) is located
on the dash to the right of the steering column.
Figure 10– 72. Switch location.
The switch is pressed or "snapped" into a rectangular
switch bezel. The attachment tilt mode switch is a two-
position switch that allows the operator to chose between
the boom lift/lower function and the extend/retract func-
tion accompanying the attachment tilt capability. For
detailed information, see 10.8.14 Joystick and the Own-
ers/Operators Manual for this vehicle.
a. Attachment Tilt Mode Switch Removal
1. Disconnect the negative (-) battery cable at the
negative battery terminal (Fig. 10– 71).
2. Carefully pry the attachment tilt mode (Fig. 10– 72)
switch and wiring out of the mounting hole in the
switch bezel.
3. Label and disconnect the wiring from the attachment
tilt mode switch. Note and mark the "top" of the
switch in relation to the switch wiring terminals, and
remove the switch from the vehicle.
b. Attachment Tilt Mode Switch Disassembly
DO NOT disassemble the attachment tilt mode switch.
Replace a defective or faulty switch with a new one.
c. Attachment Tilt Mode Switch Inspection and
Replacement
Inspect the switch terminals for continuity and shorting in
all three switch positions. Replace a defective or faulty
switch with a new one.
d. Attachment Tilt Mode Switch
Installation and Testing
1. Route the wiring through the dash and switch bezel
(Fig. 10– 73), then connect the wiring to the
attachment tilt mode switch as labeled during switch
removal.
Figure 10– 73. Attachment tilt mode switch wiring
and installation position.
2. Properly position the "top" of the switch (Fig. 10– 73),
then press or "snap" the switch into place in the
bezel.
3. Connect the negative (-) battery cable to its battery
terminal (Fig. 10– 71).
4. Clear the area around the vehicle of personnel and
any obstructions to vehicle travel.
5. Start the engine, and check the operation of the
attachment tilt mode switch functions with the switch
in both positions.
OS0402
Attachment Tilt
Mode Switch
Attachment Tilt with
Extend & Retract
Attachment
Tilt Mode
Switch
display panel symbol
2PP BLK
139 ORN / GRY
138 GRN / BLU
137 LT BLU / ORN
Attachment Tilt Switch
Right button depressed;
see owners/operators manual
for explanation of operation/functions
NOTE: 138 and 138A
are double-terminated.
138A GRN / BLU
MS2470
Top of Switch
Top of Switch