SkyTrak 3606 Service Manual - Manual (Page 300)

Section 9
9-106
9.10.6 Swing Carriage (optional)
The optional swing carriage ( 1 , Fig. 9– 69) provides a way
to swing the carriage attachment from side to side. The
swing carriage includes two cylinders that operate to pro-
vide the side to side motion.
Swing Carriage (optional) Legend
Model 3606 • Origin 10/99
1. Carriage
2. Cover, Clamp
3. HHCS, 5/16-18 x 1-1/2”
4. Pin, Carriage Pivot
5. Base, Pivot
6. Pin, Cylinder Pivot (Rod End)
7. Pin, Cylinder Pivot (Base End)
8. Shim, 2” I.D. x 10 Ga.
9. Bearing, Self Lube
10. Shim, 2” I.D. x 18 Ga.
11. Shim, 1-1/2” I.D. x 10 Ga.
12. Connector, Straight, SAE 4 - male JIC
37° x male str. thd. O-ring
13. Tie Wrap
14. Hose Assembly
15. Shim, 1-1/2” I.D. x 18 Ga.
16. Quick Disconnect, Male, SAE 8-8ORB
- female internal (Includes Item 17)
17. Seal, Nose (Not Shown)
18. Quick Disconnect, Female,
SAE 8-8ORB - female internal
(Includes Items 19, through 21)
19. Seal, Nose (Not Shown)
20. Seal, Large, Coupler Body
(Not Shown)
21. Back-up Ring for Large Seal
(Not Shown)
22. Bearing, Thrust
23. Cap, Dust
24. Plug, Dust
25. Ring, Retaining
26. Hose Assembly
27. Elbow, 90° SAE 6-8 - male
JIC 37° x male str. thd. O-ring
28. Elbow, 90° SAE 6 - male
JIC 37° x male str. thd. O-ring
29. Clamp, Half
30. Shaft, Fork Pivot 52”
31. Hub, Lock
32. HHCS, 5/8-11 x 4”
33. Nut, Hex Lock 5/8-11
34. Fork, Pallet 48” x 4” x 2” (4,000 lb
Rating)
Fork, Lumber (Not Shown)
Fork, Blocking (Not Shown)
35. Chart, Capacity
36. Decal, Danger - Tip Over Hazard
37. Nut, SAE 6 - JIC 37°
38. Reducer, Tube End, SAE 6-4 - JIC 37°
39. Elbow, 90° SAE 6-4 - male JIC 37° x
male str. thd. O-ring
40. Reducer, SAE 4-6 - male str. thd.
O-ring x female internal O-ring boss
41. Decal, Danger - No Truss Boom
42. Plug, Trim 2-1/2” Diameter