SkyTrak 3606 Service Manual - Manual (Page 19)

General Information, Specifications, and Maintenance
2-3
2.1 REPLACEMENT PARTS AND
WARRANTY INFORMATION
The replacement of any part with any other than a Sky
Trak authorized replacement part can adversely affect
the safety, performance, or durability of the vehicle, and
may void the warranty. Sky Trak International assumes
no liability whatsoever for unauthorized replacement
parts.
A warranty registration form must be filled out by the Sky
Trak distributor, signed by the purchaser, and returned to
Sky Trak when the vehicle is sold and/or put into use.
Registration activates the warranty period and helps to
assure that warranty claims are promptly processed. To
guarantee full warranty service, verify that the distributor
has returned the business reply card of the warranty reg-
istration form to Sky Trak.
2.2 SERIAL NUMBER LOCATIONS
When ordering replacement parts or making service
inquiries about the vehicle, various serial numbers are
required to help assure the provision of
correct parts and information. Before ordering parts or
initiating service inquiries, make note of the pertinent
serial numbers.
2.3 TORQUE VALUES
2.3.1 Fastener Rating
All fasteners (nuts, bolts, washers, etc.) are equal to SAE
Grade 5 (PC8.8) and are plated, unless otherwise specified.
Unless otherwise specified, the following values apply for
Grade 5 (PC8.8) nuts and bolts:
2.3.2 Straight Thread O-ring Fitting
(non-adjustable)
When the vehicle leaves the factory, it is equipped only
with straight thread O-ring fittings. Customer-added
accessories may differ; therefore, consult the manufac-
turer's product literature for information.
1. Verify that both threads and sealing surfaces are free
of burrs, nicks, scratches, and any foreign material.
2. Lubricate the new O-ring with a light coating of
hydraulic oil.
3. Tighten fitting to the proper torque according to the
following chart:
2.3.3 Straight Thread O-ring Fitting
(adjustable)
When the vehicle leaves the factory, it is equipped only
with straight thread O-ring fittings. Customer-added
accessories may differ; therefore, consult the manufac-
turer's product literature for information.
1. Verify that both mating parts are free of burrs, nicks,
scratches, and any foreign material.
2. Lubricate the new O-ring with a light coat of hydraulic
oil.
3. Back off the locknut as far as possible.
4. Screw the fitting into the port by hand until the
backup washer contacts the face of the port and is
pushed all the way towards the locknut.
5. To position the fitting, unscrew by the required
amount, but not more than one full turn.
Size Torque Size Torque
Inch lb/ft Nm mm Nm lb/ft
1/4 9 12 6.0 10 7
5/16 18 24 8.0 25 18
3/8 31 42 10.0 50 37
7/16 50 68 -- -- --
1/2 75 102 12.0 80 59
9/16 110 150 14.0 130 95
5/8 150 203 16.0 200 146
3/4 250 340 20.0 360 263
7/8 380 515 22.0 510 372
1.0 585 793 24.0 650 475
SAE
Size Torque
lb/ft Nm
4 22-26 30-35
6 46-54 62-73
8 95-105 129-142
10 125-135 170-183
12 165-175 224-237
16 245-255 332-346
20 270-290 366-393
24 365-385 495-522
Model 3606 • Origin 10/99