SkyTrak 3606 Service Manual - Manual (Page 106)

Section 4
4-20
Throttle Pedal Installation
1. Install the hex jam nut (item E, Fig. 4–34) and SAE
flat 1/4" washer (D) onto the end of the throttle cable
(G). Secure the cable to the throttle pedal (A).
Note: If throttle cable (G) replacement is required (refer
to Fig. 4–2), the cab must be unbolted from its mount and
raised slightly to permit cable removal.
2. If needed, attach one end of the extension spring (F)
to the throttle pedal lever beneath the pedal. Attach
the other end of the spring to the cable clamp (ref.).
3. Align the throttle pedal assembly (A) with its mount
holes in the cab floor (ref.).
4. Install three 1/4-20 x 1-1/4" hex-head capscrews (B),
1/4" lock washers (C) and SAE flat 1/4" washers (D)
securing the throttle pedal assembly (A) to the cab
floor. Torque to 9 lb/ft (12 Nm).
Throttle Adjustment
1. From within the cab, lightly depress the throttle pedal
(Fig. 4–35) to full-throttle position. As needed, adjust
the limit-stop screw until it touches the pedal. Tighten
the locknut to 120 to 125 lb/in (13,6 to 14,1 Nm).
Figure 4–35. Adjust the throttle limit-stop screw.
IMPORTANT: During the full throttle check:
• DO NOT operate any hydraulic function;
• DO NOT steer or apply any pressure to
the steering wheel;
• Keep the transmission in NEUTRAL (N).
2. Check the engine rpm at full throttle. If the rpm is not
2600 to 2800 rpm, readjust the throttle limit-stop
screw at the throttle pedal within the cab.
4.2.9 Mirror Replacement
Figure 4–36. Mirror mounting arrangement.
The vehicle is equipped with three rear-view mirrors (Fig.
4–36). These include two cab-mounted mirrors (items 6
and 11), one on the left (6), another on the top right (11),
and an engine hood mounted mirror (1).
MA0191
Limit-stop
screw
Locknut
Throttle
pedal
Cab
floor
WARNING: A mirror with cracked glass can
cause cuts. Handle a cracked or broken mirror
with care to help avoid personal injury.
1. Convex mirror head
2. Mirror arm assembly
3. Hex-head capscrew,
M6-1 x 20 mm
4. Lock washer, M6
5. SAE flat light washer, 1/4"
6. Rear view mirror
7. Mirror arm assembly
8. Hex-head capscrew,
M6-1 x 14 mm
9. Slotted round-head screw,
#10-24 x 5/8"
10. Lock washer, #10
11. Rear view mirror
assembly
1
2
3
4
5
6
7 8
9
10 11
4
MS0940
Model 3606 • Origin 10/99