Allied Telesis AT-S25 - Manual (Page 82)

Section II: Local and Telnet Mangement
82
Modifying a Port Trunk
To modify a port trunk from the switch, perform the following
procedure:
1. From the Main Menu, type 1 to select Ports Menu.
2. From the Ports Menu, type 3 to select Port Trunking.
The Port Trunking menu in Figure 25 on page 79 is displayed.
3. From the Port Trunking menu, type M if you wish to select a module
other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
4. Enter the ID of the module you wish to select, and press the Enter key.
5. From the Port Trunking menu, type 3 to select Modify 10/100 Trunk
Ports.
The following prompt is displayed.
Enter Trunk Number -> [1 to 5] ->
6. Enter the number of the port trunk you wish to modify; then press the
Enter key.
You could modify the ports individually (e.g., 1,2,3,4) or as a range
(e.g., 7-10).
Once you have modified the port(s) of the trunk, the following
menu selection appears in the window:
Enter trunk ports [1 - 8] ->
7. Enter the new number of the trunk port.
8. Press any key to continue.