Allied Telesis AT-S25 - Manual (Page 135)

AT-S25 Management Software User’s Guide
135
Example of Creating a Port-based VLAN
The following procedure creates the Sales VLAN illustrated in Port-
based VLAN Example on page 122. This VLAN will be assigned a VID of
two and will consist of four untagged ports, Ports 1 to 4. The VLAN will
not contain any tagged ports. The VLAN traffic will not be mirrored on
another port, nor will it be sent to the switch’s CPU.
To create the example Sales VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Menu.
2. From the VLAN Menu, type 1 to select VLAN Definition.
3. From the VLAN Definition menu, type 1 to select Create VLAN.
4. Type M if you wish to select a module other than the one currently
displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
5. Enter the ID of the module you wish to select, and press the Enter key.
6. Type 1 to select VLAN Name and enter “Sales”. Press the Enter key.
7. Type 2 to select VLAN ID (VID) and enter “2”. This is the VID value for
the new VLAN. Press the Enter key.
8. Type 4 to select Untagged Ports and enter “1-4”. These are the
untagged ports of the VLAN. Press the Enter key.
9. Type C to select Create VLAN.
10. After the switch displays the prompt notifying you that it created the
VLAN, press any key to continue.
11. Type S to select Save Configuration changes.
The new Sales VLAN has now been created.