Allied Telesis AT-S25 - Manual (Page 49)

AT-S25 Management Software User’s Guide
49
Configuring the
Management
Passwords
There are two levels of management access on an AT-8316F or an AT-
8324 Switch: Manager and Operator. When you log in as a Manager, you
could view and configure all of a switch’s operating parameters. When
you log in as an Operator, you could only view the operating
parameters; you could not change any values.
You log in as a Manager or an Operator by entering the appropriate
password when you start an AT-S25 management software.
❑ The default login password for Manager access is “friend”.
❑ The default password for Operator access is “operator”.
Note
The passwords are case sensitive.
To change the Manager or Operator password, perform the following
procedure:
1. From the Main Menu, type 4 to select Administration Menu.
2. From the Administration Menu, type 8 to select Set Passwords. The
Passwords Menu in Figure 11 is displayed.
Figure 11 Passwords Menu
3. Type 1 to change the Manager password, or type 2 to change the
Operator password.
4. When prompted, enter the current Manager or Operator password.
5. When prompted, enter the new Manager or Operator Password.
6. When prompted, re-enter Manager or Operator Password.