Allied Telesis AT-S25 - Manual (Page 114)

Section II: Local and Telnet Mangement
114
The Display RSTP Port Configuration window in Figure 35 is
displayed.
Figure 39 Display RSTP Port Configuration Window
The parameters displayed in this window are for viewing
purposes only. For description of the parameters, refer to Table 5,
STP and RSTP Parameters on page 100.
Displaying a
Port’s RSTP
Status
To display a port’s RSTP status, perform the following procedure:
1. From the Spanning Tree Menu, type 2 to select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
2. Type R to select RSTP.
3. Type 4 to select RSTP Configuration.
The STP Menu in Figure 32 on page 103 is displayed.
4. From the STP Menu, type P to select SRTP Port Parameters.
The STP Port Parameters window in Figure 33 on page 105 is
displayed.
5. From the RSTP Port Parameters window, type M if you wish to select
a module other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
6. Enter the ID of the module you wish to select, and press the Enter key.