Allied Telesis AT-S25 - Manual (Page 38)

Section II: Local and Telnet Mangement
38
Selecting a
Switch Module
in the Stack
Most of the procedures in this guide have you select the switch module
in the stack on which you want to perform the procedure.
For example, to display the status of the ports on the third switch
module, you would perform the following procedure:
1. From the Main Menu, type M to select M - Select another module.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
2. Enter 3 for the switch module ID, and press the Enter key.
Note
The number of each switch module in the menu corresponds to the
Stack ID setting on the switch. The Stack ID setting is assigned with
the Stack ID switch on the back panel of the switch.
For the location of the switch and information on how each switch
is assigned a value, refer to the AT-8316F/MT, AT-8316F/VF, AT-
8316F/SC and AT-8324 Installation Guide.