Allied Telesis AT-S25 - Manual (Page 264)

Section III: Web Browser Management
264
Configuring CoS
To configure CoS, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 2.
3. From the Layer 2 page, select the COS tab.
A graphical image of an AT-8316F or an AT-8324 Fast Ethernet
Switch is displayed.
4. Click the port where you wish to configure the CoS.
You could select only one port at a time. A selected port turns
white. (To deselect a port, click it again.)
5. Click Modify.
The COS Setting window in Figure 108 is displayed.
Figure 108 COS Setting Window
6. Enter the parameters in the window as desired.