Setting the switch’s vlan mode – Allied Telesis AT-S25 User Manual

Page 252

Text mode
Original mode

Section III: Web Browser Management

252

Setting the Switch’s VLAN Mode

This section contains the procedure for setting a switch’s VLAN mode.
You could configure a switch to support port-based and tagged VLANs
or to operate in the Basic VLAN mode.

Note
Refer to Chapter 10, Virtual LANs, for descriptions of port-based
and tagged VLANs and the Basic VLAN mode.

To set the switch’s VLAN mode, perform the following procedure:

1. From the Home Page, select Configuration.

The Configuration window is displayed with the System menu
option selected by default.

2. If the System menu option is not selected, select it and then select the

General tab.

The General tab window in The General tab in Figure 102 is
displayed.

Figure 102 Configuration - General Window