Allied Telesis AT-S25 - Manual (Page 107)

AT-S25 Management Software User’s Guide
107
Displaying Port’s STP Status and Setting
To display a port’s STP status and settings, perform the following
procedure:
1. From the Spanning Tree Menu, type 2 to select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
2. Type S to select STP.
3. Type 3 to select STP Configuration.
The STP Menu in Figure 32 on page 103 is displayed.
4. From the STP Menu, type P to select STP Port Parameters.
The STP Port Parameters window in Figure 33 on page 105 is
displayed.
5. From the STP Port Parameters window, type M if you wish to select a
module other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
6. Enter the ID of the module you wish to select, and press the Enter key.
7. In the STP Port Parameters window, type 2 to select Display STP Port
Configuration.
The Display STP Port Configuration window in Figure 35 is
displayed.
Figure 35 Display STP Port Configuration Window