Allied Telesis AT-S25 - Manual (Page 136)

Section II: Local and Telnet Mangement
136
Example of Creating a Tagged VLAN
The following procedure creates the Engineering VLAN in the top switch
illustrated in Tagged VLAN Example on page 126. This VLAN will be
assigned a VID of 3. It will consist of four untagged ports, Ports 9, 10, 11,
and 20, and two untagged ports, Ports 8 and 16. The VLAN traffic will not
be mirrored on another port, nor will it be sent to the switch’s CPU.
To create the example Engineering VLAN, perform the following
procedure:
1. From the Main Menu, type 2 to select VLAN Menu.
2. From the VLAN Menu, type 1 to select VLAN Definition.
3. From the VLAN Definition menu, type 1 to select Create VLAN.
4. Type M if you wish to select a module other than the one currently
displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
5. Enter the ID of the module you wish to select, and press the Enter key.
6. Type 1 to select VLAN Name and enter “Engineering”. Press the Enter
key.
7. Type 2 to select VLAN ID (VID) and enter “3”. This is the VID value for
the new VLAN. Press the Enter key.
8. Type 3 to select Tagged Ports and enter “8,16”. These are the tagged
ports of the VLAN. Press the Enter key.
9. Type 4 to select Untagged Ports and enter “9,10,11, 20”. These are the
untagged ports of the VLAN. Press the Enter key.
10. Type C to select Create VLAN.
11. After the switch displays the prompt notifying you that it created the
VLAN, press any key to continue.
12. Type S to select Save Configuration changes.
The new Engineering VLAN has now been created.