Allied Telesis AT-S25 - Manual (Page 155)

AT-S25 Management Software User’s Guide
155
Viewing MAC Addresses by Port & Module
This section contains the procedure for viewing the dynamic MAC
addresses that have been learned on a particular port. You could also
use this procedure to view any static MAC addresses that have been
assigned to a port.
1. From the Main Menu, type 6 to select MAC Menu.
2. From the MAC Menu, type 7 to select Show MAC addresses by port &
module.
The following prompt is displayed:
Please enter module number -> [1 to 8] ->
3. Enter the number of the module whose static and dynamic MAC
addresses you wish to view and press the Enter key.
The following prompt is displayed:
Please enter port number -> [1 - 24] ->
4. Enter the number of the port whose static and dynamic MAC
addresses you wish to view and press the Enter key.
A window is displayed with the MAC addresses of the end nodes
on the port. The columns in the window and the definitions of the
columns are the same as for the Show all MAC addresses window
on Viewing MAC Addresses on page 150.
The information in this window is for viewing purposes only.