Allied Telesis AT-S25 - Manual (Page 172)

Section II: Local and Telnet Mangement
172
Displaying a List of Host Nodes
You could use the AT-S25 software to display a list of the multicast
groups on a stack, as well as the host nodes. To display the list, perform
the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
2. From the System Config Menu, type A to select Advanced
Configuration.
3. From the Advanced Configuration window, type 1 to select IGMP
Snooping Configuration.
The IGMP Snooping Configuration window in Figure 57 is
displayed.
4. From the IGMP Snooping Configuration window, type 5 to select View
Multicast Hosts List.
The View Multicast Hosts List in Figure 58 is displayed.
Figure 58 View Multicast Hosts List Window
The information in this window is for viewing purposes only. The
columns are described in the table below:
PARAMETER DESCRIPTION
MulticastGroup The multicast address of the group.
VLAN The VID of the VLAN in which the port is an untagged
member.
Module The module on the stack that is being used.
Port The port(s) on the stack to which one or more host
nodes of the multicast group are connected.
Host IP The IP address(es) of the host node(s) connected to the
port.