Allied Telesis AT-S25 - Manual (Page 236)

Section III: Web Browser Management
236
Displaying STP Status and Settings
Displaying
Bridge’s STP
Status and
Settings
To display a bridge’s STP status and settings, perform the following
procedure:
1. From the Home page, select Monitoring.
2. From the Monitoring menu, select Layer 2 tab.
3. From the Layer 2 window, select the Spanning Tree tab.
The Spanning Tree window in Figure 89 is displayed.
Figure 89 Monitoring - Spanning Tree Window
The parameters displayed in this window are for viewing purpose
only. For description of these parameters, refer to Table 8, STP
and RSTP Parameters on page 230.
Displaying
Port’s STP
Status and
Settings
To display the port’s STP status or settings, perform the following
procedure:
1. From the Spanning Tree window in Figure 89, select a port or a group
of ports you wish to display the status or settings.