Allied Telesis AT-S25 - Manual (Page 80)

Section II: Local and Telnet Mangement
80
3. From the Port Trunking menu, type M if you wish to select a module
other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
4. Enter the ID of the module you wish to select, and press the Enter key.
5. From the Port Trunking menu, type 1 to select Create 10/100 Trunk.
The following prompt is displayed.
Enter Trunk Number -> [1 to 5] ->
6. Enter the number of the port that will constitute the port trunk; then
press the Enter key.
You could specify the ports individually (e.g., 1,2,3,4) or as a range
(e.g., 7-10).
Once you have specified the port(s) of the trunk, the following
menu selection appears in the window:
Enter Trunk Name ->
Enter trunk ports [1 - 8] ->
Press any key to continue.
7. Configure the ports on the remote switch for port trunking.
8. Connect the cables to the ports of the trunk on the switch.
The port trunk is ready for network operation.
Creating Gigabit
Port Trunk
To create a Gigabit port trunk, perform the following procedure:
1. From the Main Menu, type 1 to select Ports Menu.
2. From the Ports Menu, type 3 to select Port Trunking.
The Port Trunking menu in Figure 25 on page 79 is displayed.
3. From the Port Trunking menu, type M if you wish to select a module
other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
Enter the ID of the module you wish to select, and press the Enter
key.