Allied Telesis AT-S25 - Manual (Page 234)

Section III: Web Browser Management
234
The STP Configuration Spanning Tree window in Figure 86 is
displayed.
Figure 87 STP Configuration Spanning Tree Window
3. Enter or modify the STP configuration settings as desired.
For description of the parameters displayed in this window, refer
to Table 8, STP and RSTP Parameters on page 230.
4. Click Apply.
Changes are immediately activated on the switch.
Configuring a
Port’s STP
Settings
To configure a port’s STP settings, perform the following procedure:
1. From the STP Configuration Spanning Tree window, as displayed in
Figure 87 on page 234, select a port.
A selected port turns white. (To deselect a port, click it again.)
2. Click Modify.