Allied Telesis AT-S25 - Manual (Page 238)

Section III: Web Browser Management
238
Configuring RSTP
Configuring a
Bridge’s RSTP
Settings
This section contains the procedure for configuring a bridge’s RSTP
settings.
Caution
The bridge provides default RSTP parameters that are adequate for
most networks. Changing them without prior experience and an
understanding of how RSTP works might have a negative effect on
your network. You should consult the IEEE 802.1w standard before
changing any of the RSTP parameters.
Considering that you have enabled RSTP as instructed in Enabling or
Disabling STP or RSTP on page 229.
To configure RSTP, perform the following procedure:
1. From the Spanning Tree window, as displayed in Figure 86 on page
229, with SRTP Configuration as your selection.
2. Click Configure.