Allied Telesis AT-S25 - Manual (Page 254)

Section III: Web Browser Management
254
Changing a PVID Value
The procedure in this section explains how to change a PVID value for a
port. As explained in Port-based VLAN Overview on page 118, a port
receives a PVID when it is assigned as an untagged port to a VLAN. A
port’s PVID will be the same as the VLAN’s VID to which it has been
assigned. For example, if you assign Port 4 on the switch as an untagged
port to a VLAN with a VID of 7, the port is assigned a PVID also of 7.
The assignment of PVIDs is performed automatically by the AT-S25
software. There should be little need for you to manually change a PVID
yourself. But the AT-S25 software does allow you to adjust the value if
necessary.
To change a PVID for a port, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 2.
3. From the Layer 2 page, select the COS tab.
A graphical image of an AT-8316F or an AT-8324 Fast Ethernet
Switch is displayed.
4. Click the port whose PVID value you wish to configure. You could
select only one port at a time.
A selected port turns white. (To deselect a port, click it again.)
5. Click Modify.
The COS Setting window in Figure 103 is displayed.
Figure 103 COS Setting Window