Allied Telesis AT-S25 - Manual (Page 133)

AT-S25 Management Software User’s Guide
133
9. Type C to select Create VLAN.
If the switch is successful in creating the new VLAN, you will see
the following message:
SUCCESS - Press any key to continue.
10. Press any key to continue.
The VLAN Definition menu in Figure 44 on page 130 is displayed.
11. Type S to select Save Configuration changes.
You could repeat this procedure to create additional VLANs.
To verify that the VLAN was created correctly, perform the following
procedure:
1. From the VLAN Definition menu, type 4 to select Show All VLANs.
The Show All VLANs window as shown Figure 46 is displayed.
4 - Untagged
Ports Use this selection to add or remove untagged ports
from the VLAN.You could specify the ports individually,
as a range, both individually and as a range, all ports
(ALL), or no port (NONE).
To add or remove untagged ports, enter the new list of
untagged ports for the VLAN by using the following
examples for guidelines. For example:
• If the VLAN will contain individual untagged ports,
you would enter “5,8” for this value.
• If the VLAN will contain a range of untagged ports of
5-9, you would enter “4-7” for this value.
• If the VLAN will contain both individual and in a range
of untagged ports of 3,5,7-9, you would enter “3,5,7-
9” for this value.
• If the VLAN will contain all untagged ports, you would
enter ALL for this value.
• If the VLAN contains untagged ports and you wish to
remove them all, you would enter NONE for this value.
You could not remove untagged ports directly from the
Default VLAN. Instead, you remove an untagged port
from the Default VLAN by assigning the port as an
untagged port to another VLAN.
NOTE: An untagged port removed from a VLAN is
automatically returned to the Default VLAN as an
untagged port.
PARAMETER DESCRIPTION