Allied Telesis AT-S25 - Manual (Page 137)

AT-S25 Management Software User’s Guide
137
Modifying a VLAN
Note
You need to know the VID of the VLAN you wish to modify in order
to perform this procedure. To view the VLAN VIDs, refer to the
procedure Displaying VLAN Information on page 139.
To modify a VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Menu.
2. From the VLAN Menu, type 1 to select VLAN Definition.
3. From the VLAN Definition menu, type 2 to select Modify VLAN.
The Modify VLAN window in Figure 49 is displayed.
Figure 47 Modifying VLAN Menu
4. Type M if you wish to select a module other than the one currently
displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
5. Enter the ID of the module you wish to select, and press the Enter key.
6. Type 1 to select VLAN ID (VID).
The following prompt is displayed:
Enter new value -> [1 to 2048] ->