Enabling or disabling stp or rstp – Allied Telesis AT-S25 User Manual

Page 229

AT-S25 Management Software User’s Guide

229

Enabling or Disabling STP or RSTP

To enable or disable spanning tree protocol (STP) or rapid spanning tree
protocol (RSTP) on the bridge, perform the following procedure:

1. From the Home page, select Configuration.

2. From the Configuration page, select Layer 2 tab.

3. From the Layer 2 page, select the Spanning Tree tab.

The Spanning Tree window in Figure 86 is displayed.

Figure 86 Configuration - Spanning Tree Window

4. To enable or disable spanning tree, click the Enable Spanning Tree

check box. A check indicates that the feature is enabled while no
check indicates that the feature is disabled. The default is disabled.

5. If you are activating spanning tree, select either the STP or RSTP in the

Active Protocol Version section of the window. The default is RSTP.

Note
Only one spanning tree protocol can be active on the switch at a
time.

6. Click Apply.