Allied Telesis AT-S25 - Manual (Page 205)

AT-S25 Management Software User’s Guide
205
❑ To specify the IP addresses of up to four management
workstations on your network to receive traps from the switch,
use the selections below:
◗ Trap Receiver 1
◗ Trap Receiver 2
◗ Trap Receiver 3
◗ Trap Receiver 4
Note
The Enable SNMP Access check box the window controls whether
the switch can be remotely managed using an SNMP application
program. If the check box is empty, the switch cannot be managed
through SNMP. This is the default.
4. Click Apply.
Changes are immediately activated on the switch.
Note
For instructions on configuring IGMP Snooping using the web
browser, refer to Chapter 25, IGMP Snooping on page 266.