Allied Telesis AT-S25 - Manual (Page 153)

AT-S25 Management Software User’s Guide
153
Figure 55 Show all multicast MAC addresses Window
This window is slightly different than the other Show MAC
addresses window. The information displayed in this window is
also for viewing purposes only.
The columns are described in the table below:
Viewing MAC
addresses on
base ports only
This selection is useful if you are managing an AT-8316F or an AT-8324
Switch with GBIC or expansion modules installed, and you wish to view
the MAC addresses only on Ports 1 to 24. To view only the MAC
addresses on the base ports, perform the following procedure:
1. From the Main Menu, type 6 to select MAC Menu.
2. From the MAC Menu, type 4 to select Show MAC addresses on base
ports.
A window is displayed with the MAC addresses on the base ports.
An example of the Show MAC addresses on base ports window is
displayed, as shown in Figure 56.
PARAMETER DESCRIPTION
MAC Address The MAC address of the node connected to the switch.
VlanID The VID of the VLAN to which the port is an untagged
member.
Module The selected module.
Port List The port list on the switch where the multicast MAC
address was learned.