Allied Telesis AT-S25 - Manual (Page 61)

AT-S25 Management Software User’s Guide
61
3 - Negotiation Configures a port for Auto-Negotiation or to manually
set a port’s speed and duplex mode.
Possible settings for this parameter are:
• Auto: Sets a port’s speed and duplex mode
automatically. (default)
• Manual: Set a port’s speed and duplex mode
manually.
If you select Auto, the switch will set both speed and
duplex mode for the port automatically.
If you select Manual, two additional selections are
displayed in the window:
4 - Duplex ..............Half
5 - Speed .............. 10MB
You use these two selections to set the port’s duplex
and speed mode.
Possible settings for these 2 selections are:
4 - Duplex:
• Full = Full-duplex
• Half = Half-duplex
5 - Speed:
• 0010 = 10MB
• 0100 = 100MB
• 1000 = 1000MB (AT-8324 uplink only)
F - Flow Control Uses a special pause packet to stop the end node from
sending frames. The pause packet notifies the end node
to stop transmitting for a specified period of time.
Possible settings for this parameter are:
• Enable
• Disable (default)
NOTE: This parameter only applies to ports operating in
full-duplex mode.
PARAMETER DESCRIPTION