Allied Telesis AT-S25 - Manual (Page 222)

Section III: Web Browser Management
222
Modifying a Port Trunk
To modify a port trunk, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 1.
3. Select the Port Trunking tab.
The Port Trunking tab window in Figure 81 is displayed.
4. From the Port Trunking tab window, click to select the trunk number
you wish to modify.
5. Click Modify.
The Port Trunking window in Figure 83 is displayed.
Figure 83 Example of Port Trunking Window - Modify
The selected trunk number is displayed for viewing purpose only.
6. Change the trunk name, if desired.
7. Select or deselect the ports you wish to modify for the existing trunk.
These ports must be within the same group range as specified in
the trunk number section.
8. Click Apply.
The updated port trunk is immediately activated on the switch.
You could now connect the data cables to the ports of the trunk
on the switch.