Allied Telesis AT-S25 User Manual
Page 55
AT-S25 Management Software User’s Guide
55
Returning the AT-S25 Software to the Factory Default Values
The procedure in this section returns all AT-S25 software parameters to
their default values. This procedure also deletes any VLANs that you
have created on the switch.
Note
The AT-S25 software default values can be found in Appendix A,
AT-S25 Default Settings on page 273.
To return the AT-S25 management software to its default settings,
perform the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
2. From the System Config Menu, type 6 to select Reset Configuration to
Factory Defaults.
The following prompt is displayed:
The switch will reboot after set to factory default.
Do you want to proceed? [Yes/No] ->
3. Type Y for yes or N for no.
The following prompt is displayed:
Do you want to reset static IP, Subnet and Gateway
as well? [Yes/No] ->
4. If you type Y for yes, all switch parameters including the IP address,
subnet mask, and gateway address are changed to their default
values. If you type N for no, all switch parameters excluding the IP
address, subnet mask, and gateway address are changed to their
default values.
The following prompt is displayed when Y is selected:
Configuration is set to factory default!
Reboot the switch..
The operating parameters are returned to their default values and
the switch is reset.