Allied Telesis AT-S25 - Manual (Page 239)

AT-S25 Management Software User’s Guide
239
The RSTP Configuration Spanning Tree window in Figure 86 is
displayed.
Figure 91 RSTP Configuration Spanning Tree Window
3. Enter or modify the RSTP configuration settings as desired.
For description of the parameters displayed in this window, refer
to Table 8, STP and RSTP Parameters on page 230.
4. Click Apply.
Changes are immediately activated on the switch.
Configuring a
Port’s RSTP
Settings
To configure a port’s RSTP settings, perform the following procedure:
1. From the RSTP Configuration Spanning Tree window, as displayed in
Figure 87 on page 234, select a port.
A selected port turns white. (To deselect a port, click it again.)
2. Click Settings.