Allied Telesis AT-S25 - Manual (Page 214)

Section III: Web Browser Management
214
The columns in the window are described below:
PARAMETER DESCRIPTION
PortName/
UplinkType PortName is the name of the port, and UplinkType is
the type of the applique’ in the uplink slot (AT-A14,
AT-A15, AT-A17, AT-A18, or AT-A19).
NOTE: The UplinkType only applies to the uplink
ports.
State The current state of the port.
Possible settings for this parameter are:
• Enable (default)
• Disable
Nego The status of Auto-Negotiation on the port.
Possible settings for this parameter are:
• Auto - Indicates that the port is using Auto-
Negotiation to set operating speed and duplex
mode.
• Manual - Indicates that the operating speed and
duplex mode have been set manually.
Link The status of the link between the port and the end
node connected to the port.
Possible settings for this parameter are:
• Up - indicates that a valid link exists between the
port and the end node.
• Down - indicates that the port and the end node
have not established a valid link.
Speed The operating speed of the port.
Possible settings for this parameter are:
• 10 Mbps = 10 MB
• 100 Mbps = 100 MB
• 1000 Mbps = 1 GB (AT-8324 uplink only)
Duplex The duplex mode of the port.
Possible settings for this parameter are:
• Half-duplex
• Full-duplex
PVID The port VLAN identifier currently assigned to the
port.