Allied Telesis AT-S25 - Manual (Page 111)

AT-S25 Management Software User’s Guide
111
Figure 37 RSTP Port Parameters Menu
6. From the RSTP Port Parameters window, type M if you wish to select
a module other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
7. Enter the ID of the module you wish to select, and press the Enter key.
8. From the RSTP Port Parameters window, type 1 to select Configure
RSTP Port Settings.
The following prompt is displayed:
Start Port to configure [1 - 24] ->
9. Enter the number of the port you wish to configure. To configure a
range of ports, enter the first port of the range. Press the Enter key.
The following prompt is displayed:
End Port to Configure [1 - 24] ->
❑ To configure just one port, enter the same port number here as
you entered in the previous step.
❑ To configure a range of ports, enter the last port of the range.
10. Press the Enter key.
The Configure RSTP Port Settings menu in Figure 38 on page 112
is displayed.