Allied Telesis AT-S25 - Manual (Page 113)

AT-S25 Management Software User’s Guide
113
Displaying Port’s RSTP Status and Settings
Unlike the information displayed for STP, the RSTP status and settings
information are listed separated in the AT-S25 software, under the
following menus:
❑ Display RSTP Port Settings
❑ Display RSTP Port State
Displaying a
Port’s RSPT
Settings
To display a port’s RSTP settings, perform the following procedure:
1. From the Spanning Tree Menu, type 2 to select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
2. Type R to select RSTP.
3. Type 4 to select RSTP Configuration.
The STP Menu in Figure 32 on page 103 is displayed.
4. From the STP Menu, type P to select RSTP Port Parameters.
The RSTP Port Parameters window in Figure 33 on page 105 is
displayed.
5. From the RSTP Port Parameters window, type M if you wish to select
a module other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
6. Enter the ID of the module you wish to select, and press the Enter key.
7. In the RSTP Port Parameters window, type 2 to select Display RSTP Port
Settings.