HP 3PAR Remote Copy Software - Manual (Page 90)

3.28 Synchronous Long Distance Remote Copy Setup
Remote Copy User’s Guide InForm OS Version 2.3.1
The admitrcopyvv command adds the specified volume (vv2) to the primary volume
group (Group2). At the same time, it also adds the secondary volume (vv2.remote) to
the corresponding secondary volume group on the target system (Group2.r125).
4 Start replication for the volume groups created in step 1 :
where is the name of the primary volume group (Group2).
The startrcopygroup command begins the copying of data. Because this is the first time
this command has been run for this volume group, the existing data is copied from the
primary to the secondary volume group.
3.6 Synchronous Long Distance Remote Copy Setup
Use the procedures described in this section to set up Synchronous Long Distance Remote Copy
on your storage servers. See Synchronous Long Distance Configuration on page 2.12 and
Requirements and Restrictions on page 2.41 for information about Synchronous Long Distance
Remote Copy setups.
In this section, as illustrated by Figure 3-8 :
■ The primary system is a four-node cluster called InServA and the backup systems are four-
node clusters called InServB and InServC.
■ InServA is the primary storage system
◆ Target name: InServB
◆ Links:
◆ Node 2 IP address 10.100.33.195
◆ Node 3 IP address 10.101.33.195
◆ Target name: InServC
◆ Links:
◆ Node 2 IP address: 10.100.33.63
◆ Node 3 IP address: 10.101.33.63
On InServ2:
# startrcopygroup