HP 3PAR Remote Copy Software - Manual (Page 200)

B.64 showrctransport
Remote Copy User’s Guide InForm OS Version 2.3.1
■ IPAddress . IP address of the Ethernet port indicated in the N:S:P column.
■ PeerIPAddress . IP address of the peer Ethernet port to which the port indicated in the
N:S:P column is connected.
■ Netmask . Netmask for the IP address.
■ Gateway . Address of the gateway.
■ MTU . Maximum Transfer Unit (MTU) size for the specified Remote Copy interface (default is
1500). The largest supported value is 9000 and the smallest is 100.
■ Rate . Actual bit rate of the port indicated in the N:S:P column.
■ Duplex . Values can be either Full or Half .
The following example displays status and information about the end-to-end transport for
RCFC ports:
The columns in the previous example are identified as follows:
■ N:S:P . The physical position of the port, in the format node:slot:port.
■ Remote_Node_WWN . World Wide name of the node to which the port indicated in the N:S:P
column connects.
■ Remote_Port_WWN . World Wide name of the target port to which the port indicated in
the N:S:P column connects.
■ State . Indicates whether the end-to-end transport is ready to be used for Remote Copy.
Can be one of the following:
◆ new . The target port is newly discovered and has not yet been used for Remote Copy.
◆ incomplete . Port indicated in the N:S:P column is activated and ready, but the target
port is not yet enabled.
◆ ready . Remote copy link is activated and ready for use.
◆ missing . Ready link was disconnected.
cli% showrctransport -rcfc
N:S:P Remote_Node_WWN Remote_Port_WWN State
5:3:2 2FF70002AC000029 21110002AC000029 ready
4:1:1 2FF70002AC000029 20020002AC000029 ready