HP 3PAR Remote Copy Software - Manual (Page 81)

3.19 Setting Up Remote Copy
InForm OS Version 2.3.1 Remote Copy User’s Guide
◆ is the link IP address for the target system (for example,172.16.1.12
and 172.16.2.12).
3.5.1.2 Setting Up the Backup Server
The commands used to set up the backup storage server (InServ2) are the same as those used
to set up the primary server (InServ1), except that they create the links in the opposite
direction.
To set up the backup storage server (InServ2)
1 Start Remote Copy as follows:
2 Define a target for InServ2:
◆ is the target name (in this example, InServ1)
◆ IP states that this is an IP link.
◆ specifies the node that contains the IP connections to the target.
NOTE: The command for RCFC target creation is:
#creatercopytarget FC
NOTE: You can only configure one link per target definition per node. All
examples in this guide use the first pattern illustrated in Figure 2-9 on page 2.17 ,
where links are created between the lowest numbered node in each member of
the Remote Copy pair and the highest numbered node in each member of the
Remote Copy pair.
On InServ2:
# startrcopy
On InServ2:
# creatercopytarget IP :
: