HP 3PAR Remote Copy Software - Manual (Page 180)

B.44 setrcopytarget
Remote Copy User’s Guide InForm OS Version 2.3.1
enable|disable
Enables or disables the target.
OPTIONS
None.
SPECIFIERS
Specifies the target name for the target definition previously created with the
creatercopytarget command (see creatercopytarget on page B.20).
This specifier can only be used with the pol subcommand. The policy can be one of the
following:
mirror_config|no_mirror_config
Specifies that all configuration commands ( creatercopygroup , removercopygroup ,
admitrcopyvv , dismissrcopyvv , setrcopygroup pol/period ,
startrcopygroup , and stoprcopygroup ) involving the specified target are
duplicated ( mirror_config ) or not duplicated ( no_mirror_config ). If not specified,
all configuration commands are duplicated.
The new name for the indicated target. This specifier can only be used with the name
subcommand.
Specifies the maximum throughput for the indicated target's links, and is used to limit the
total throughput of the links. The throughput value can take a [ g | G ] suffix (gigabytes), [ m | M ]
suffix (megabytes) or [ k | K ] suffix (kilobytes) to indicate size (with no space between the
specified value and size type). The default is kilobytes. Specifying a value of 0 removes the
throughput. This specifier can only be used with the tput subcommand.
NOTE: The no_mirror_config specifier should only be used to allow recovery
from an unusual error condition and only used after consulting your 3PAR
representative.