HP 3PAR Remote Copy Software - Manual (Page 250)

C.32 1-to-N Unidirectional Asynchronous Periodic Disaster Recovery Example
Remote Copy User’s Guide InForm OS Version 2.3.1
The following example displays the showrcopy command output on InServ2 300 seconds
after InServ1 has become unavailable:
To initiate disaster recovery for a Remote Copy pair with asynchronous periodic volume
groups:
1 On the failover system, make all secondary groups primary by reversing the direction of the
failed targets for each group. Issuing the setrcopygroup failover command switches
every secondary group for the specified target. For this example, this is done by reversing
the failed target InServ1 for the primary group primary_group_1 on InServ2 using
the setrcopygroup failover command as follows:
On InServ2:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
InServ1 7 IP failed mirror_config
Link Information
Target Node Address Status Options
InServ1 0 10.100.33.61 Down
InServ1 1 10.101.33.61 Down
receive 0 10.100.33.61 Down
receive 1 10.101.33.61 Down
Group Information
Name Target Status Role Mode Options
periodic_group_1.r96 InServ1 Stopped Secondary Periodic over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
remotevv.0 21 localvv.0 413 Stopped Thu Dec 14 18:23:52 PST 2006
remotevv.1 22 localvv.1 414 Stopped Thu Dec 14 18:23:52 PST 2006
On InServ2:
# setrcopygroup failover -t InServ1